What are you looking for?

hardness converter hardness converter app for andriodshenyang tx patented productshenyang tx expert of aluminum products testingshenyang tx on site hardness testing with high accuracyshneyang tx samll and light simple operation

Standard Specification for High Strength Steel Castings in Heavy Sections

This specification covers cast alloy steels in the normalized and tempered or quenched and tempered condition, suitable for high strain gradient conditions. One test  block for each heat is required. The test block configuration and size are specified. Tension and Charpy impact tests and oxygen, nitrogen, and   hydrogen gas content tests shall be performed. The steel shall be made by electric furnace process with methods, such as argon-oxygen-decarburization, to conform to the maximum gas level. Heat treatment     procedure shall be done. Multiple austenitizing and tempering are permitted.

The chemistry grade shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, nickel, chromium, molybdenum, and aluminum. Residual elements include:  zirconium, copper, titanium, tungsten, vanadium, columbium, and boron. A product analysis shall be made for specification conformance. Casting shell and core depth zone shall be established and  examined. Repair methods such as grinding and welding are detailed.

Tension and Charpy impact tests


1. This specification covers cast alloy steels in the normalized and tempered or quenched and tempered  condition, in section sizes through 37 in. (940 mm), suitable for high strain gradient conditions such as those encountered in hooks, shackles, support frames, and other lifting devices. The classes of steel in   this specification are weldable only with qualified procedures.

2. Section range and class selection will depend on design and service conditions. Users should note that this specification contemplates mechanical property gradients.

3. The values stated in inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in non-conformities with the specification. Inch-pound units are applicable for material ordered to this Specification and SI units for material ordered to this Specification.

4.  If, by agreement, castings are to be supplied in a partially completed condition, that is, all of the  provisions of the product specification have not been filled, then the material marking and certification are to reflect the extent to which the product specification requirements have been met.